Skytrak 6036 Service Manual Bedienungsanleitung PDF herunterladen (Seite 66)

Section 5. Wheel Assembly, Tires, and Axle

5-21

Model 6036 S/N 9B0499 and Before

turn and align any hole in the nut with a

major spline on the spindle. Mark the end

of the aligned spline on the edge of the

spindle. Make sure the hub rotates freely.

(d) Install roll pin (19) on the back face of

planetary ring gear (17) and mark its

location on the front face of the gear.

(e) Install planetary ring gear, making sure roll

pin is locked into locknut hole. Align mark

on the edge of the spindle with the mark

on the front face of the planetary ring gear.

(f) Install spacer (16), sun spur gear (15), and

retaining ring (14) on the axle shaft.

8.

On an axle with service brakes:

(a) Using a suitable lifting device, install the

hub assembly onto the spindle.

(b) Install the planetary ring gear/piston/

retainer unit on the spindle assembly,

being sure oil passage hole in ring gear is

to the bottom of the axle at 6 o’clock.

(c) Gradually increase torque on retainer

screws (25, Fig. 5.8) using a crossing

pattern until 45 lb-ft (61 N m) is achieved

on each screw.

(d) Install lining stop plates (14 and 17, Fig.

5.8 and Fig. 5.12) and discs (18).

9. Install the planetary gear assembly as de-

scribed in paragraph 5.2.2.

5.2.5 Steering Cylinder and Tie Rod

a. Removal

Refer to page 20 through 22 of Spicer

®

Dana

Maintenance Manual for Axle Models PS/PR-7036

for removal instructions.

Fig. 5.12 Park Lock Removal

b. Cleaning and Drying

1. Clean all parts with approved petroleum based

cleaner.

2. Use clean lint free towels to dry components

after cleaning.

3. After drying, components should be lightly

coated with oil or rust preventive to protect

them from corrosion.

c. Inspection and Replacement

1. Be sure rod is straight and undamaged. If rod

is bent or damaged, install new rod.

2. Check condition of tube, attaching hardware

and hydraulic hoses. Repair or replace as

required.

d. Installation

Refer to page 24 of Spicer

®

Dana Maintenance

Manual for Axle Models PS/PR-7036 for installa-

tion instructions.

5.2.6 Park Lock Unit

The park lock unit consists of the park lock and a

yoke shaft.

a. Removal

Refer to page 54 of Spicer

®

Dana Maintenance

Manual for Axle Models PS/PR-7036 for removal

instructions.

b. Disassembly

Refer to page 55 of Spicer

®

Dana Maintenance

Manual for Axle Models PS/PR-7036 for disassem-

bly instructions.

COVER PLATE HEX BOLTS

RETAINER RING

SOCKET HEAD

CAPSCREWS

PINION NUT

DUST SLINGER

YOKE SHAFT

BRAKE MODULE WITH PRES-

SURE AND SPRING PLATES

WASHER

MA0281

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 279 280

Kommentare zu diesen Handbüchern

Keine Kommentare