Skytrak 6036 Service Manual Bedienungsanleitung PDF herunterladen (Seite 77)

3.37

Model 6036 Legacy

Boom

10. At the rear of the inner boom, place the male ends of

the hoses (attachment tilt and optional auxiliary

hydraulics) inside the inner boom. Be sure the hoses

are coiled up and inside the boom completely.

Note: Use a hoist with a lifting capacity of 5000 lbs

(2268 kg) and slings to install the inner boom.

11. Carefully slide the end of the boom into the front of the

intermediate boom. Readjust the position of the sling

as needed to help balance the boom during installation.

Insert the inner boom into the intermediate boom as

far as possible.

12. Install the side wear pads on the intermediate boom:

Note: Shim ALL side wear pads as needed to maintain

a total minimum gap of .07-.13" (1,8-3,3 mm) in the

horizontal direction.

a. Slide the inner boom over to one side as far as it

will go, to allow wear pad installation.

b. Place the wear pad inserts (Fig. 3-80, 1) into the

cavities of the side wear pads (2). Place the

shims (3) onto the wear pad and align the holes.

c. Apply Loctite

242 threadlocker to the threads of

the 3/8-16 x 3/4" capscrews (Fig. 3-80, 4). Slide

the wear pad with shims between the inner boom

and the intermediate boom with the offset of each

wear pad away from the center. Align the holes

and secure in place with the capscrews (4), 3/8"

lockwashers (5) and 3/8" flat washers (6). Be

careful not to push the wear pad inserts out of the

wear pads.

d. Torque all wear pad mounting capscrews to

31 ±3 lb/ft (42 ±4 Nm).

e. Fill all wear pad cavities with a good grade of

lithium-based EP grease.

f. Repeat Steps a-e to install the side wear pads on

the other side of the intermediate boom.

Figure 3-80 Install the Intermediate

Boom Front Side Wear Pads

13. Install the top wear pads on the inside of the

intermediate boom:

a. Place the wear pad inserts (Fig. 3-81, 1) into the

cavities of the top wear pads (2).

b. Apply Loctite

242 threadlocker to the threads of

the 3/8-16 x 1-1/2" capscrews (Fig. 3-81, 3).

Slide the wear pads with the spacers (4) between

the inner boom and the intermediate boom, with

the offset of each wear pad toward the center.

Align the holes and secure in place with the

capscrews (3) and 3/8" lockwashers (5). Be

careful not to push the wear pad inserts out of

the wear pads.

c. Torque all wear pad mounting capscrews to

31 ±3 lb/ft (42 ±4 Nm).

d. Fill all wear pad cavities with a good grade of

lithium-based EP grease.

Figure 3-81 Install the Intermediate

Boom Front Wear Pads

14. Pull the male ends of the hoses out the rear of the

inner boom. Stretch the hoses out straight behind

the vehicle.

MA8050

MA8060

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 459 460

Kommentare zu diesen Handbüchern

Keine Kommentare

Skytrak 6036 Service Manual Bedienungsanleitung Seite 77

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spezialmaschinen Skytrak 6036 Service Manual