Skytrak 6036 Service Manual Bedienungsanleitung PDF herunterladen (Seite 441)

9.89

Model 6036 Legacy

Electrical System

9.15.7 Steering

Certain steering functions are dependent upon electrical

operations, described below. Consult the Owners/

Operators Manual for further information related to

steering.

a. Steer Select Switches

The steer select switch (Fig. 9-78, 1) is located on the

right side of the operator’s control panel. It is a three-

position switch that is pressed or “snapped” into a

rectangular switch bezel.

Figure 9-78 Steer Select Switch Positions

The three-position switch (Fig. 9-78, 1) is a single-pole,

double throw toggle switch that has three positions. It has

a multiple-connector plug on its underside that connects

to the cab wiring harness. Wiring from the plug connects

the switch with power from the fuse panel bus bar, and to

the operator’s instrument cluster and the steer select

solenoids on the vehicle.

Steer select solenoids are energized or de-energized

accordingly to provide the type of steering selected. The

switch allows four-wheel steer (Fig. 9-78, 2) (the rear

wheels turn opposite the front wheels), two-wheel steer

(3) (the front wheels only) or crab steer (4) (the rear

wheels turn in the same direction as the front wheels).

b. Steer Modes and Conditions

Four-Wheel Steer Mode

With the steer select switch (Fig. 9-78, 1) in the

lower position (Fig. 9-78, 2), the following

conditions must be met:

1. Front wheels (Fig. 9-79, 1) must steer in the

direction that the steering wheel is turned.

Figure 9-79 Four-Wheel Steer

2. Rear wheels (Fig. 9-79, 2) must steer in the

opposite direction from which the steering wheel is

turned. (Refer to Section 9.7.10, “Four-Wheel Steer

Circuit and Troubleshooting.”)

Front-Wheel Steer Mode

With the steer select switch in the center

position (Fig. 9-78, 3), the following condition

must be met:

1. The front wheels (Fig. 9-80, 1) must steer in the

direction that the steering wheel is turned.

Figure 9-80 Front-Wheel Steer

2. Rear wheels (Fig. 9-80, 2) must remain in a fixed

FORWARD position and not move. (Refer to Section

9.7.9, “Front Steer Circuit and Troubleshooting.”)

OH19412

OH2611

OH1660

OH2601

OH1670

1 2 ... 436 437 438 439 440 441 442 443 444 445 446 ... 459 460

Kommentare zu diesen Handbüchern

Keine Kommentare

Skytrak 6036 Service Manual Bedienungsanleitung Seite 441

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spezialmaschinen Skytrak 6036 Service Manual