Skytrak 6036 Service Manual Bedienungsanleitung PDF herunterladen (Seite 207)

9-19

6036, 6042, 8042, 10042, 10054

Electrical System

9. Turn ignition key switch to the RUN position, and

operate windshield wiper in both LOW and HIGH

speeds to ensure proper operation and that correct

wiper travel is achieved.

10. If previously removed, install hydraulic hoses under

the dash. (Refer to Section 4.3.1, “Steering Column

and Steering Valve.”)

11. Install the previously removed dash panels.

12. Close and secure the rear door.

9.8.2 Skylight Wiper Motor

a. Removal

1. Park the machine on a firm, level surface, level the

machine, fully retract the boom, lower the boom,

place the transmission control lever in

(N) NEUTRAL, engage the park brake and shut the

engine OFF.

2. Place a Do Not Operate Tag on both the ignition key

switch and the steering wheel, stating that the

machine should not be operated.

3. Open the rare door. Allow the system fluids to cool.

4. Properly disconnect the battery.

5. Remove the wiper arm (5) from the wiper motor

shaft.

6. Disconnect the washer hose from the top hose

fitting.

7. From inside the cab, remove screws from top locknut

plate.

8. Unclip the plastic motor cover (6) and remove.

9. From the top of the cab, remove the nut from the

wiper motor shaft.

10. From inside the cab, pull the wiper motor down and

away from the roof.

11. Label and disconnect the cab harness connectors

from the wiper motor.

b. Disassembly

DO NOT disassemble the motor. The motor is not

serviceable. Replace motor if found to be defective.

c. Inspection and Replacement

Inspect the motor terminals for continuity. Replace motor

if continuity is not found.

d. Installation and Testing

1. Hold wiper motor up toward cab top and install the

cab harness connectors.

2. With the help of an assistant, insert the wiper motor

through the roof hole and have the assistant thread

the nut onto the wiper motor shaft. Ensure that the

motor housing is facing the front of the cab.

3. Install the wiper arm onto the wiper motor shaft.

4. Install the screws through the plastic motor cover

and into the top locknut plate and tighten.

5. Connect washer hose to top hose fitting.

6. Properly connect the battery.

7. Remove the Do Not Operate Tags from both the

ignition key switch and the steering wheel.

8. Turn the ignition key to the RUN position and turn

skylight wiper switch to the ON position. Ensure

wiper stays on the window through a full stroke. Turn

the skylight wiper switch to the OFF position.

9. Engage the washer switch and ensure washer fluid

is sprayed on the skylight window. Turn the ignition

key switch to the OFF position.

10. Close and secure the rear door.

MA8361

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 275 276

Kommentare zu diesen Handbüchern

Keine Kommentare

Skytrak 6036 Service Manual Bedienungsanleitung Seite 207

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spezialmaschinen Skytrak 6036 Service Manual